Exporting Data From A Job To Another Device - Leica GPS1200+ Technical Reference Manual

16.4
General
Access
Export data step-by-
step
Convert...\Export Data from Job

Exporting Data from a Job to another Device

Data can be transferred to a Leica TPS400/700 via RS232.
Refer to "16.2 Accessing the Data Export Functionality" to access EXPORT Export ASCII
Data from Job.
The following table explains the most common settings. Refer to the stated chapter for more
information on screens.
Step Description
1. EXPORT Export ASCII Data from Job
<Export To: RS232>
<Port:> displays the port currently configured to be used with RS232.
IFACE (F5) accesses CONFIGURE Export Job Interface. To
choose the port and device to which the data should be exported.
2. FILT (F4) to set the sort and filter settings for export. Accesses
EXPORT Sorts & Filters.
3. EXPORT Sorts & Filters, Points page
<Sort:> The order in which points, lines and areas are exported.
<Filter:> Defines which points are exported.
PAGE (F6) changes to the Lines or Areas page. The setting for
<Filter:> on these pages defines which lines or areas are exported.
GPS1200+
Refer to
chapter
16.1
9.6
351