Table of Contents
Advertisement
NTRIP via Internet
Step
Description
10.
Enter the TCP/IP Port number for the port that is open on the caster
for a connection from the NTRIP server.
11.
Enter the access details (mountpoint and password) for the NTRIP
Server to connect to the NTRIP Caster.
12.
For a Real-Time out data stream, activate the Auto connect on start
check box.
All data streams except Real-Time out start streaming data as soon
as the Configuration of the interface is finished. If the Auto connect
on start check box stays unchecked, a Connect link will appear for
this data stream in the Configuration - Interfaces page. This link
allows a connection to the NTRIP caster without using the Start
button on the sensor.
13.
If a Real-Time out data stream has been configured, press the Start
button to connect to the NTRIP caster and start streaming data.
14.
If a different interface than Real-Time out has been configured, press
the Connect link in Configuration - Interfaces to connect to the NTRIP
caster. The data stream is already active.
Check the Message Log and the Port summary page on the web
interface to ensure that the connection to the NTRIP caster was
successful. On the Port summary page move the mouse over the IP
address to view connections details.
GPS1200+
Refer to
chapter
780
Advertisement
Table of Contents
