Manually Entering A Reference Line/Arc - Leica GPS1200+ Technical Reference Manual

Geodetic satellite receiver

Hide thumbs Also See for GPS1200+:

Table of Contents

Access step-by-step

Reference Line

Manually Entering a Reference Line/Arc

This chapter does not apply for staking to polylines.

This screen allows a reference line/arc to be temporarily defined using a number of methods.

Refer to "42.2 Accessing Reference Line" to access REFLINE Reference

Line/Arc Begin.

CONT (F1) to access REFLINE Reference Task Menu.

REFLINE Reference Task Menu

This screen defines the task to be performed.

Measure to Line or Measure to Arc: Calculates the coordinates of a point from

its position relative to the reference line/arc.

Stake to Line or Stake to Arc: Allows points to be staked relative to the reference

Gridstake Line or Gridstake Arc: Allows a grid to be staked out relative to the

reference line/arc.

CONT (F1) to access REFLINE Choose Reference Line, Reference page.

REFLINE Choose Reference Line, Reference page

Select <Ref to Use: Manually Enter>.