Configuration Of Annotations - Leica GPS1200+ Technical Reference Manual

22.4.3
Configuration of anno-
tations step-by-step
Config...\Interfaces... - General

Configuration of Annotations

Step Description
1. Refer to "22.4.1 Overview" to access CONFIGURE ASCII Input.
2. ANNOT (F2) to access CONFIGURE Annotations to be Used.
3. CONFIGURE Annotations to be Used
<Annotation:> The annotation to which the ASCII message is to be stored.
<Accept ASCII:> Activates the recording of ASCII messages with the selected
annotation. <Accept ASCII: No> if the seismic record is configured to be used with
<Annotation: Annotation 4>.
<Message Desc:> The description for the ASCII message being received. This
description is then displayed in other screens, e.g. in STATUS ASCII Input - XX.
<Message ID:> The message ID to identify a particular ASCII message coming
from the device. The message is then saved to the annotation. Refer to "22.4.2
Configuration of an ASCII Input Interface". The following characters can be used
as filter:
^ To accept strings starting with the subsequent characters. For example ^1
accepts 12 but not 21.
$ To accept strings ending with the preceding characters. For example 1$ accepts
21 but not 12.
. To accept any character except newline.
[ ] To accept a set of characters. For example [0-9] accepts all numbers.
GPS1200+ 519