Defining Reference Line/Arc Slopes - Leica GPS1200+ Technical Reference Manual

42.4.5
Description
Access step-by-step
REFLINE
Define Slope
Reference Line

Defining Reference Line/Arc Slopes

This chapter does not apply for staking to polylines.
It is possible to measure points and stake points on slopes related to a reference line/arc. A
slope can be defined and cut/fill values can then be displayed to the slope when measuring
along the reference line/arc. The slope is a plane from the reference line/arc and extends
along the length of the reference line/arc.
Slopes can be used when measuring to a reference line/arc, staking a point relative to a
reference line/arc or performing a grid stakeout relative to a reference line/arc.
Step Description
1. Refer to "42.2 Accessing Reference Line" to access REFLINE Reference
Line/Arc Begin.
2. CONT (F1) to access REFLINE Reference Task Menu.
3. REFLINE Reference Task Menu
This screen defines the task to be performed.
Select a task except Stake to Polyline.
4. CONT (F1) to access REFLINE Choose Reference Line.
5. SLOPE (F3) to access REFLINE Define Slope.
This screen contains different fields depending on the options chosen for <Heights:> in
REFLINE Configuration, Heights page, and the selected task.
GPS1200+ 1057