Table of Contents
Advertisement
42.4.3
Description
Access step-by-step
REFLINE
Choose Reference Line,
Reference page
Reference Line
Selecting a Reference Line/Arc from the Job
This chapter does not apply for staking to polylines.
New reference lines/arcs can be created, existing reference lines/arcs can be edited and
previously entered reference lines/arcs can be selected from the <Control Job:>.
Step
Description
1.
Refer to "42.2 Accessing Reference Line" to access REFLINE Reference
Line/Arc Begin.
2.
CONT (F1) to access REFLINE Reference Task Menu.
3.
REFLINE Reference Task Menu
This screen defines the task to be performed. For a description of the tasks refer
to "42.4.2 Manually Entering a Reference Line/Arc".
Select a task except Stake to Polyline.
4.
CONT (F1) to access REFLINE Choose Reference Line, Reference page.
5.
REFLINE Choose Reference Line, Reference page
Select <Ref to Use: Select from Job>.
This screen contains the Reference page and the Map page. The explanations for the
softkeys and the fields are as for manually entering a reference line. The <Method:> field is
not available and all line definition fields are outputs, all other differences are described
below.
The fields shown depend on:
•
the task selected in REFLINE Reference Task Menu
GPS1200+
1045
Advertisement
Table of Contents
