Point Sorting And Filters; Sorting And Filters For Points, Lines And Areas - Leica GPS1200+ Technical Reference Manual

Geodetic satellite receiver

Hide thumbs Also See for GPS1200+:

Table of Contents

Manage...\Data

Point Sorting and Filters

The sort settings define the order of the objects in the active job. The filter settings define the

objects to be viewed.

Three types of filters are available:

Point filter:

An active point filter shows selected points in MANAGE Data: Job Name,

Points page.

Line filter:

An active line filter shows selected lines in MANAGE Data: Job Name,

Lines (X) page.

Area filter:

An active area filter shows selected areas in MANAGE Data: Job Name,

Areas (X) page.

The sort and filter settings are stored in the job. They are remembered after turning off the

When a job becomes active, then the sort and filter settings of this job are saved in the

SystemRAM. If the CompactFlash card is formatted then these last used sort and filter

settings are used for the job Default.

Changing the active job does influence the sort settings for the objects. The filter settings are

set to those of the selected job.

An active filter for an object is indicated in MANAGE Data: Job Name by

right hand side of the page name.

located on the