Router Pim - Digisol DG-GS4826S Management Manual

C 49 | Multicast Routing Commands
HAPTER
PIM Multicast Routing

router pim

Table 187: PIM-DM and PIM-SM Multicast Routing Commands (Continued)
Command Function
PIM-SM Commands
ip pim bsr-candidate Configures the switch as a Bootstrap Router (BSR)
candidate
ip pim register-rate-limit Configures the rate at which register messages are
sent by the Designated Router (DR)
ip pim register-source Configure the IP source address of a register message
to an address other than the outgoing interface
address of the designated router (DR) leading toward
the rendezvous point (RP)
ip pim rp-address Sets a static address for the rendezvous point
ip pim rp-candidate Configures the switch rendezvous point (RP) candidate GC
ip pim spt-threshold Prevents the last-hop PIM router from switching to
Shortest Path Source Tree (SPT) mode
ip pim dr-priority Sets the priority value for a DR candidate
ip pim join-prune-interval Sets the join/prune timer
clear ip pim bsr rp-set Clears RP entries learned through the BSR
show ip pim bsr-router Displays information about the BSR
show ip pim rp mapping Displays active RPs and associated multicast routing
entries
show ip pim rp-hash Displays the RP used for the specified multicast group
This command enables IPv4 Protocol-Independent Multicast routing
globally on the router. Use the no form to disable PIM multicast routing.
S
YNTAX
[no] router pim
D S
EFAULT ETTING
Disabled
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
This command enables PIM-DM and PIM-SM globally for the router. You
u
also need to enable PIM-DM or PIM-SM for each interface that will
support multicast routing using the
mode command, and make any changes necessary to the multicast
protocol parameters.
To use multicast routing, IGMP proxy can not enabled on any interface
u
of the device (see the
– 1270 –
ip pim dense-mode
ip igmp proxy command).
Mode
GC
GC
GC
GC
GC
IC
IC
PE
PE
PE
PE
or ip pim sparse