Displaying Continuity Check Errors - Edge-Core ECS4510-12PD Web Management Manual

Displaying Continuity
Check Errors
Use the Administration > CFM > Show Information (Show Continuity Check Error)
page to display the CFM continuity check errors logged on this device.
Parameters
These parameters are displayed:
◆
Level – Maintenance level associated with this entry.
◆
Primary VLAN – VLAN in which this error occurred.
◆
MEP ID – Identifier of remote MEP.
◆
Interface – Port at which the error was recorded.
◆
Remote MAC – MAC address of remote MEP.
◆
Reason – Error types include:
LEAK – MA x is associated with a specific VID list
■
in this MA can pass through the bridge port, no MEP is configured facing
outward (down) on any bridge port for this MA, and some other MA y, at a
higher maintenance level, and associated with at least one of the VID(s)
also in MA x, does have a MEP configured on the bridge port.
■ VIDS – MA x is associated with a specific VID list
facing inward (up) on this MA on the bridge port, and some other MA y,
associated with at least one of the VID(s) also in MA x, also has an Up MEP
configured facing inward (up) on some bridge port.
EXCESS_LEV – The number of different MD levels at which MIPs are to be
■
created on this port exceeds the bridge's capabilities.
OVERLAP_LEV – A MEP is created for one VID at one maintenance level, but
■
a MEP is configured on another VID at an equivalent or higher level,
exceeding the bridge's capabilities.
◆
MA Name – The maintenance association for this entry.
Web Interface
To show CFM continuity check errors:
1.
Click Administration, CFM.
2.
Select Show Information from the Step list.
3.
Select Show Continuity Check Error from the Action list.
12. This definition is based on the IEEE 802.1ag standard. Current software for this switch
only supports a single VLAN per MA. However, since it may interact with other devices
which support multiple VLAN assignments per MA, this error message may be reported.
Chapter 13
– 477 –
| Basic Administration Protocols
Connectivity Fault Management
12
, one or more of the VIDs
12
, an MEP is configured