Edge-Core ECS4110-28T Management Manual page 91

28/52-port gigabit ethernet layer 2+ switch
Hide thumbs Also See for ECS4110-28T:
Table of Contents

Advertisement

ff02::1
IPv6 link MTU is 1500 bytes
ND DAD is enabled, number of DAD attempts: 3.
ND retransmit interval is 1000 milliseconds
ND advertised retransmit interval is 0 milliseconds
ND reachable time is 30000 milliseconds
ND advertised reachable time is 0 milliseconds
ND advertised router lifetime is 1800 seconds
Console#
Address for Multi-segment Network — Before you can assign an IPv6
address to the switch that will be used to connect to a multi-segment
network, you must obtain the following information from your network
administrator:
Prefix for this network
IP address for the switch
Default gateway for the network
For networks that encompass several different subnets, you must define
the full address, including a network prefix and the host address for the
switch. You can specify either the full IPv6 address, or the IPv6 address
and prefix length. The prefix length for an IPv6 network is the number of
bits (from the left) of the prefix that form the network address, and is
expressed as a decimal number. For example, all IPv6 addresses that start
with the first byte of 73 (hexadecimal) could be expressed as
73:0:0:0:0:0:0:0/8 or 73::/8.
To generate an IPv6 global unicast address for the switch, complete the
following steps:
From the global configuration mode prompt, type "interface vlan 1" to
1.
access the interface-configuration mode. Press <Enter>.
From the interface prompt, type "ipv6 address ipv6-address" or
2.
"ipv6 address ipv6-address/prefix-length," where "prefix-length"
indicates the address bits used to form the network portion of the
address. (The network address starts from the left of the prefix and
should encompass some of the ipv6-address bits.) The remaining bits
are assigned to the host interface. Press <Enter>.
Type "exit" to return to the global configuration mode prompt. Press
3.
<Enter>.
To set the IP address of the IPv6 default gateway for the network to
4.
which the switch belongs, type "ipv6 default-gateway gateway," where
"gateway" is the IPv6 address of the default gateway. Press <Enter>.
Console(config)#interface vlan 1
Console(config-if)#ipv6 address 2001:DB8:2222:7272::66/64
Console(config-if)#exit
Console(config)#ipv6 default-gateway 2001:DB8:2222:7272::254
Console(config)end
– 91 –
| Initial Switch Configuration
C
2
HAPTER
Basic Configuration

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ecs4110-28pEcs4110-52tEcs4110-52p

Table of Contents