Edge-Core ECS4110-28T Management Manual page 6

A T G
BOUT HIS UIDE
R H
EVISION ISTORY
This section summarizes the changes in each revision of this guide.
J 2014 R
ULY ELEASE
This is the second version of this guide. This guide is valid for software
release v1.1.2.0. It includes information on the following changes:
Adds information for the ECS4110-28T and ECS4110-28P.
◆
Updated information in
◆
Updated information under
◆
page 76.
◆ Updated information in
Updated information in
◆
Added the section "Configuring NTP" on page
◆
Added the section "Configuring Time Servers" on page
◆
◆ Updated description of Media Type under
page 156.
◆ Added the section "Displaying Transceiver Data" on page
Added Timout Mode under
◆
Added the section "Configuring Load Balancing" on page
◆
Updated information under
◆
◆ Added description of L3 Interface parameter under
VLAN Groups" on page
Added description of Mask parameter under
◆
VLANs" on page 227.
Added the section "Configuring MAC Address Learning" on page
◆
◆ Updated the parameter list under
page 242.
Added description of BPDU Flooding and Cisco Prestandard Status
◆
parameters under "Configuring Global Settings for STA" on page
Added description of BPDU Flooding and Admin Edge Port parameters
◆
under "Configuring Interface Settings for STA" on page
Updated the parameter list under
◆
page 288.
Updated the paramter list under
◆
Authentication" on page
– 6 –
Table 1, "Key Features," on page
"Description of Software Features" on
Table 2, "System Defaults," on page
Table 6, "Switch Main Menu," on page
139.
"Configuring by Port List" on
"Configuring a Dynamic Trunk" on page
"Traffic Segmentation" on page
202.
"Configuring MAC-based
"Configuring Loopback Detection" on
"Configuring a Class Map" on
"Configuring Local/Remote Logon
311.
75.
82.
106.
140.
170.
179.
189.
193.
"Configuring
231.
243.
250.