Subaru IMPREZA 2002 Service Manual page 135

MECHANICAL
ENGINE ASSEMBLY
24) Install the ST to torque converter clutch case.
(AT model)
ST 498277200 STOPPER SET
25) Remove the engine from vehicle.
(1) Slightly raise the engine.
(2) Raise the transmission with garage jack.
(3) Move the engine horizontally until main
shaft is withdrawn from clutch cover.
(4) Slowly move the engine away from engine
compartment.
CAUTION:
Be careful not to damage adjacent parts or
body panels with crank pulley, oil level gauge,
etc.
26) Remove the front cushion rubbers.
B: INSTALLATION
1) Install the front cushion rubbers.
Tightening torque:
34 N-m (3.5 kgf-m, 25.3 ft-16)
2) Install the engine onto transmission.
(1) Position the engine in engine compartment
and align it with transmission.
CAUTION:
Be careful not to damage adjacent parts or
body panels with crank pulley, oil level gauge,
etc.
(2) Apply a small amount of grease to spline of
main shaft. (MT model)
3) Tighten the bolts which hold upper side of trans-
mission to engine.
Tightening torque:
50 N.m (5.7 kgf-m, 36.9 ft-16)
I
83M2044
4) Remove the lifting device and wire ropes.
I
5 ) Remove the garage jack.
M E(S0HC)-37