Subaru IMPREZA 2002 Service Manual page 80

PURGE CONTROL SOLENOID VALVE
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)
5. Purge Control Solenoid Valve
A: REMOVAL
1 ) Disconnect the ground terminal from battery.
2) Remove the bolt which installs purge control
so-
lenoid valve onto intake manifold.
3) Take out purge control solenoid valve through
the bottom of the intake manifold.
4) Disconnect the connector and hoses from purge
control solenoid valve.
B: INSTALLATION
Install in the reverse order of removal.
Tightening torque:
16 N.m (1.6 kgf-m, 11.6 ft-lb)
CAUTION:
Carefully connect the evaporation hoses.
+To intake
manifold
To fuel -e-
Pipe
02 M 1 893A
C: INSPECTION
Make sure the hoses are not cracked or loose
EC(S0HC)-6