Subaru IMPREZA 2002 Service Manual page 156

CAMSHAFT
MECHANICAL
16)
Remove the plug from rear side of camshaft.
CAUTION:
Do not remove the oil seal unless necessary.
Do not scratch the journal surface when re-
moving the oil seal.
B: INSTALLATION
1) Apply a coat of engine oil to camshaft journals
and install the camshaft.
2) Install the camshaft cap.
(1) Apply liquid gasket on the periphery of cam-
shaft cap.
Liquid gasket:
THREE BOND 12808
P/N KO877YAO18
NOTE:
Apply a coat of 3 mm (0.1 2 in) dia. (A): liquid ghor,et
along edge (B) of camshaft cap (C) mating surface.
S2M1199B
(2) Temporarily tighten the bolts (9) through (j)
in alphabetical sequence.
B2M2612E
(3) Install the valve rocker assembly.
\
- \
B2M261 f
(4) Tighten the bolts (a) through (h) in alphabet-
ical sequence.
Tightening torque:
25 N.m (2.5 kgf-m, 18.1 fi-lb)
( b )
B2M2621 B
(5) Tighten the TORX bolts (i) through (n) in al-
phabetical sequence using ST.
ST 499427000 TORX PLUS
Tightening torque:
18 N.m (1.8 kgf-m, 13.0 ff-lb)
-(
I
( i )
B2M2621 C
ME(S0HC)-58