Subaru IMPREZA 2002 Service Manual page 318

GENERATOR
STARTlNG/CHARGING SYSTEMS
C: DISASSEMBLY
1) Heat the portion (A) of rear cover to
50°C
(1 22°F) with heater drier.
2) Remove the four through bolts. Then insert the
tip of a flat-head screwdriver into the gap between
the stator core and front bracket. Pry then apart to
disassemble.
3) Hold the rotor with a vise and remove the pulley
nut.
G6M0066
I
CAUTION:
When holding the rotor with vise, insert alumi-
num plates or wood pieces on the contact sur-
faces of the vise to prevent rotor from damage.
\ - ,
H6M0498B
(A) Front bracket
(B) Pulley
(C) Nut
(D) Rotor
4) Unsolder connection between rectifier and stator
coil to remove the stator coil.
CAUTION:
Finish the work rapidly (less than three sec-
onds) because the rectifier cannot withstand
heat very well.
5) Remove the screws which secure the
I C
regula-
tor to rear cover, and unsolder connection between
I C
regulator and rectifier to remove the
I C
regula-
tor.
SC-14