Subaru IMPREZA 2002 Service Manual page 157

CAMSHAFT
MECHANICAL
(6) Tighten the bolts
(0)
through (v) in alphabet-
ical sequence.
Tightening torque:
10 N.m (1.0 kgf-m, 7.2 ft-lb)
I ( b )
B2M2621D
(7) Tighten the bolts (w) through (x) in alphabet-
ical sequence.
Tightening torque:
10 N.m (1.0 kgf-m, 7.2 ft-lb)
I I
B2M2621 E
3) Apply a coat of grease to oil seal lips and install
the oil seal (A) on camshaft using ST1 and ST2.
CAUTION:
Use a new oil seal.
ST1 499597000 OIL SEAL GUIDE
ST2 499587500 OIL SEAL INSTALLER
4) Install the plug using ST.
ST 499587700 OIL SEAL INSTALLER
5) Adjust the valve clearance. <Ref. to ME(S0HC)-
31, ADJUSTMENT, Valve Clearance.>
6) Install the rocker cover and connect PCV hose.
7) Install the oil level gauge guide. (LH side only)
8) Install the camshaft position sensor support. (LH
side only)
9) Install the belt cover No. 2 (RH).
Tightening torque:
10) Install the belt cover No. 2 (LH).
Tightening torque:
5 N-m ( 0 . 5 kgf-m, 3.6 ft-lb)
5 N.m (0.5 kgf-m, 3.6 ft-lb)
11) Install the tensioner bracket.
Tightening torque:
25 N.m (2.5 kgf-m, 18.1 ft-lb)
H2M2380
I
Install the crankshaft sprocket. <Ref. to
ME (SOH C) -54, Cranks haft
Sprocket.>
13) Install the camshaft sprocket. <Ref. to ME(S0-
HC)-52, INSTALLATION, Camshaft Sprocket.>
14) Install the timing belt assembly. <Ref. to
ME(S0HC)-48, INSTALLATION, Timing Belt As-
sembly.>
15) Install the belt cover. <Ref. to ME(S0HC)-46,
INSTALLATION, Belt Cover.>
16) Install the crankshaft pulley. <Ref. to ME(S0-
HC)-45, INSTALLATION, Crankshaft Pulley.>
17) Install the V-belt. <Ref. to ME(S0HC)-43, IN-
STALLATION, V- bel t
.
>
IN STALLATI 0 N ,
M E(S0HC)-59