GENERAL DESCRIPTION
SPEED CONTROL SYSTEMS
Free play
At pedal pad
Stroke
At pedal pad
Accelerator pedal
1. General Description
A: SPECIFICATION
1
-
4 mm
(0.04
- 0.16
in)
52
-
57 mm (2.05
-
2.24 in)
B: COMPONENT
(1
)
Accelerator bracket
(2)
Stopper
(3)
Bushing
(4)
Clip
(5)
Accelerator spring
(6)
Accelerator pedal spring
(1 1 )
Accelerator plate
(7)
Accelerator pedal lever
(12) Clip
( 8 )
Spring pin
. .
.
- .
(9)
Accelerator pedal
Tightening torque: N-m (kgf-m, ft-lb)
(1 0)
Accelerator stopper
T: lS(1.8, 13.0)
C: CAUTION
Wear work clothing, including a cap, protective
goggles, and protective shoes during operation.
sion, before removal, installation or disassembly.
Keep the disassembled parts in order and pro-
tect them from dust and dirt.
Before removal, installation or disassembly, be
sure to clarify the failure. Avoid unnecessary re-
moval, installation, disassembly, and replacement.
Be careful not to burn your hands, because each
part in the vehicle is hot after running.
Be sure to tighten fasteners including bolts and
nuts to the specified torque.
Place shop jacks or safety stands at the specified
points.
Before disconnecting electrical connectors of
terminal from battery.
.
Remove contamination, including dirt and corro-
SenSOrS O r Units, be Sure to disconnect negative
s
P-2