Subaru IMPREZA 2002 Service Manual page 362

SUBARU SELECT MONITOR
ENGINE (DIAGNOSTICS)
9. READ CURRENT DATA FOR AT.
1) On the ((Main Menu,) display screen, select the {Each System Check} and press the [YES] key.
2) On the ((System Selection Menu>> display screen, select the {Transmission Control System} and press the
[YES] key.
3) Press the [YES] key after displayed the information of transmission type.
4) On the ((Transmission Diagnosis,, display screen, select the {Current Data Display & Save} and press the
[YES] key.
5) On the ((Data Display Menu,, display screen, select the {Data Display} and press the [YES] key.
6) Using the scroll key, move the display screen up or down until the desired data is shown.
A list of the support data is shown in the following table.
Contents
Battery voltage
Rear vehicle speed sensor signal
Front vehicle speed sensor signal
Engine speed signal
Automatic transmission fluid temperature signal
Throttle position signal
Display Unit of measure
Battery Voltage V
Vehicle Speed
# i
Vehicle Speed #2
ATF Temp. "C or O F
km/h or MPH
km/h or MPH
Engine Speed rPm
Throttle Sensor Voltage V
Gear position
Line pressure control duty ratio
Lock up clutch control duty ratio
Transfer clutch control dutv ratio
Power
SUPP~V
for throttle Dosition sensor
I
Throttle Sensor Power
I
V
I
Gear Position
-
Line Pressure Duty Ratio
%
Lock Up Duty Ratio %
Transfer Dutv Ratio %
Torque converter turbine speed signal
2-4 brake timing pressure control duty ratio
Intake manifold pressure sensor voltage
2 wheel drive switch signal
Kick down switch signal
Stop lamp switch signal
Anti lock brake system signal
Cruise control system signal
NeutraVParking range signal
Reverse range signal
Drive range signal
3rd ranae sianal
AT Turbine Speed rPm
2-4B Duty Ratio
YO
Mani. Pressure Voltage V
2WD Switch ON or OFF
Kick Down Switch ON or OFF
Stop Lamp Switch ON or OFF
ABS Signal ON or OFF
Cruise Control Signal ON or OFF
NIP Range Signal ON or OFF
R Range Signal ON or OFF
D Range Signal
ON or OFF
3rd Range Signal
ON or OFF
2nd range signal
1
2nd Range Signal ON or OFF
NOTE:
For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.
1 st range signal
I
1st Range Signal
EN(S0HC)-38
ON or OFF
Shift control solenoid A
Shift control solenoid B
Torque control output signal #1
Toraue control outwt siunal #2
Shift Solenoid #I
Shift Solenoid #2
Torque Control Signal #1
Toruue Control Signal #2
ON or OFF
ON or OFF
ON or OFF
ON or OFF
Torque control cut signal
2-4 brake timing control solenoid valve
Low clutch timing control solenoid valve
Automatic transmission diagnosis indicator lamp
Torque Control Cut Sig.
2-4 Brake Timing Sol.
Low Clutch Timing Sol.
AT Diagnosis Lamp
ON or OFF
ON or OFF
ON or OFF
ON or OFF