Subaru IMPREZA 2002 Service Manual page 239

WATER PUMP
COOLING
4) Install the left-hand camshaft sprockets by using
ST.
ST 499207400 CAMSHAFT SPROCKET
WRENCH
Tightening torque:
98 N-m (10.0 kgf-m, 72.4 ft-lb)
2M1161A
5) Install the camshaft position sensor. <Ref. to
FU(D0HC TURBO)-31, INSTALLATION, Cam-
shaft Position Sensor.>
6) Install the belt idler No. 2 (C).
7) Install the belt idler (B).
8) Install the automatic belt tension adjuster (A)
which has a tension rod held by a pin. <Ref. to
SION ADJUSTER ASSEMBLY AND BELT IDLER,
INSTALLATION, Timing Belt Assembly.>
Tigh tening torque:
ME(D0HC TURBO)-50, AUTOMATIC BELT TEN-
39.4 N-m (4.0 kgf-m, 28.9 ft-16)
S2M1
-
9) Install the timing belt. <Ref. to ME(D0HC TUR-
BO)-51, TIMING BELT, INSTALLATION, Timing
Belt Assembly.>
10) Install the V-belts. <Ref. to ME(D0HC TUR-
BO)-44, INSTALLATION , V-belt
.
>
11) Install the radiator main fan and sub fan motor
assemblies. <Ref. to CO-47, INSTALLATION, Ra-
diator Main Fan and Fan Motor.> and <Ref. to CO-
48, INSTALLATION, Radiator Sub Fan and Fan
Motor.>
12) Install the reservoir tank.
13) Connect the over flow hose.
14) Lift-up the vehicle.
15) Connect the radiator outlet hose (A) and heater
hose (B) to the water pump.
16) Connect the water by-pass hose (C) and oil
cooler hose (D).
17) Install the bolt which installs water by-pass pipe
onto the oil pump.
I
I
S2M0027
1
18) Connect the connectors to radiator main fan
and sub fan motors.
19) Install the radiator under cover.
20) Install the under cover.
21) Lower the vehicle.
CO-33