Inspection Mode - Subaru IMPREZA 2002 Service Manual

INSPECTION MODE
ENGINE (DIAGNCSTICS)
12.lnspection Mode
A: OPERATION
1. PREPARATION FOR THE INSPECTION
MODE
Raise the vehicle using a garage jack and place on
safety stands or drive the vehicle onto free rollers.
WARNING:
Before raising the vehicle, ensure parking
brakes are applied.
Do not use a pantograph jack in place of a
safety stand.
Secure a rope or wire to the front and rear
towing or tie-down hooks to prevent the lateral
runout of front wheels.
Do not abruptly depresshelease the clutch
pedal or accelerator pedal during works even
when engine is operating at low speeds since
this may cause the vehicle to jump off free roll-
ers.
In order to prevent the vehicle from slipping
due to vibration, do not place any wooden
blocks or similar items between the safety
stands and the vehicle.
Since the rear wheels will also rotate, do not
place anything near them. Also, make sure that
nobody goes in front of the vehicle.
B2M2969A
2. SUBARU SELECT MONITOR
After performing diagnostics and clearing the mem-
ory, check for any remaining unresolved trouble da-
ta.
1) Prepare the Subaru Select Monitor kit. <Ref. to
EN(S0HC)-8, PREPARATION TOOL, General De-
scription.>
2 ) Connect the diagnosis cable to Subaru Select
Monitor.
3) Insert the cartridge into Subaru Select Monitor.
<Ref. to EN(S0HC)-8, PREPARATION TOOL,
General Description.>
4) Connect the test mode connector (A) at the low-
er portion of instrument panel (on the driver's side),
to the side of the center console box.
EN(S0HC)-40