Subaru IMPREZA 2002 Service Manual page 137

ENGINE ASSEMBLY
MECHANICAL
(5) Install the front side V-belt, and adjust it.
<Ref. to ME(S0HC)-43, FRONT SIDE BELT,
INSTALLATION, V-belt .>
(6) Install the resonator chamber.
33 N-m (3.4 kgf-m, 24.6 ft-lb)
Tightening torque:
11) Tighten the nuts which hold lower side of trans-
mission to engine.
Tightening torque:
50 N-m (5.1 kgf-m, 36.9 ft-lb)
13) Install the front and center exhaust pipe.
<Ref. to EX(S0HC)-6, INSTALLATION, Front Ex-
haust Pipe.>
14) Connect the following hoses:
(1) Fuel delivery hose, return hose and evapo-
ration hose
(2) Heater inlet and outlet hoses
(3) Brake booster vacuum hose
15) Connect the following connectors:
(1) Engine ground terminals
Tightening torque:
14 N-m (1.4 kgf-m, 10.1 ft-lb)
(2) Engine harness connectors
(3) Generator connector and terminal
(4)
A/C
compressor connectors
(5) Power steering pressure switch
(1) Accelerator cable
(2) Cruise control cables (With cruise control)
16) Connect the following cables:
CAUTION:
After connecting each cable, adjust them.
17) Install the air cleaner case stay.
Tightening torque:
16 N.m (1.6 kgf-m, 11.6 ft-lb)
18) Install the A/C pressure hoses.
<Ref. to AC-30, INSTALLATION, Hose and Tube.>
CAUTION:
Use new O-rings.
Tightening torque:
25 N.m (2.5 kgf-m, 18. I ft-lb)
12) Tighten the nuts which install the front cushion
rubber onto crossmember.
Tightening torque:
CAUTION:
Make sure the front cushion rubber mounting
bolts (A) and locator (B) are securely installed.
85 N-m (8.7 kgf-m, 63 ft-lb)
19) Install the radiator to vehicle. <Ref. to CO-41,
I N STALL AT1 0 N , Radiator .
>
20) Install the ATF cooler pipe. <Ref. to AT-49, IN-
STALLATION, ATF Cooler Pipe and Hose.>.
21) Install the under cover.
22) Install the battery in the vehicle, and connect
cables.
I
B2M3880A
M E(S0HC)-39