Subaru IMPREZA 2002 Service Manual page 27

INTAKE MANIFOLD
FUEL INJECTION (FUEL
SYSTEMS)
11) Install the purge control solenoid valve.
Tightening torque:
16 N-m (1.6 kgf-m, 11.8 ff-lb)
16) Install the fuel pipe protector RH.
Tightening torque:
19 N.m (1.9 kgf-m, 13.7 ff-lb)
\\ n
02M3487
12) Connect the hoses to the purge control sole-
noid valve.
CAUTION:
Carefully connect the evaporation hoses.
+To intakc
manifold
To fuel
+
Pipe
I
B2M1893P
13) install the engine harness onto the intake man-
ifold.
14) Connect the connectors to the fuel injectors
and purge control solenoid valve.
15) Hold the engine harness by harness band (A)
and harness bracket (9).
Tightening torque:
16 N-m (1.6 kgf-m, 11.8 ff-lb)
I
EN11731
NOTE:
Do
not use harness band on harnesses where they
are supposed to be protected by the fuel pipe pro-
tecto r
.
B2M4130
17) Install the fuel pipe protector LH.
Tightening torque:
19 N-m (1.9 kgf-m, 13.7 ff-lb)
18) Connect the pressure regulator vacuum hose
to the intake manifold.
//
H2M2961
19) install the air assist injector solenoid valve to
the bracket.<Ref. to FU(S0HC)-37, INSTALLA-
TION, Air Assist Injector Solenoid Valve.>
20) Install the throttle body to the intake mani-
fold.<Ref. to FU(S0HC)-14, INSTALLATION,
Throttle Body.>
21) Install the intake air temperature and pressure
sensor. <Ref. to FU(S0HC)-34, INSTALLATION,
Intake Air Temperature and Pressure Sensor.>
22) Connect the connector to the intake air temper-
ature and pressure sensor.
FU(S0HC)-25