Subaru IMPREZA 2002 Service Manual page 632

DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC)
ENG IN E (DIAGNOSTICS)
Step
r
CHECK INHIBITOR SWITCH GROUND LINE
Measure the resistance of harness between
inhibitor switch connector and engine ground.
Connector & terminal
(T7)
No.
7
-
Engine ground:
I
CHECK INHIBITOR SWITCH.
Measure the resistance between inhibitor
switch connector receptacle's terminals in
selector lever "N" and " P positions.
Terminals
NO. 7 - NO.
12:
1
CHECK SELECTOR CABLE CONNECTION.
Check
Is the resistance less than 5
Q?
Is the resistance less than 1
n?
Is there any fault in selector
cable connection to inhibitor
switch?
Yes
30 to step 8.
So to step 9.
3epair selector
:able connection.
:Ref. to CS-27,
NSPECTION,
;elect Cable.>
No
Repair open circuit
in harness
between inhibitor
switch connector
and starter motor
ground line.
NOTE:
In this case, repaii
the following:
Open circuit in
harness between
inhibitor switch
connector and
starter motor
ground line
Poor contact in
starter motor con-
nector
Poor contact in
starter motor
ground
* Starter motor
Replace the inhibi-
tor switch. <Ref. to
AT-28, Inhibitor
Switch.>
Contact with SOA
(distributor) ser-
vice.
NOTE:
Inspection by DTM
IS
required, be-
cause probable
cause is deteriora-
tion of multiple
parts.
EN(S0HC)-308