Subaru IMPREZA 2002 Service Manual page 58

FUEL FILLER PIPE
FUEL INJECTION (FUEL SYSTEMS)
B: INSTALLATION
1) Hold the fuel filler flap open.
2) Set the fuel saucer (A) with rubber packing (C)
and insert the fuel filler pipe into hole from the inner
side of apron.
3) Align the holes in fuel filler pipe neck and set the
cup (B), and tighten the screws.
NOTE:
If the edges of rubber packing are folded toward the
inside, straighten it with a screwdriver.
4) Install the evaporation pipe.
5 ) Connect the evaporation hose to the pipe.
EN112:
6) Insert the fuel filler hose (A) approximately 35 to
40 mm (1.38 to 1.57 in) over the lower end of fuel
filler pipe and tighten the clamp.
CAUTION:
Do not allow clips to touch evaporation hose
(B) and rear suspension crossmember.
7) Insert the evaporation hose approximately 25 to
30 mm (0.98 to 1.18 in) into the lower end of evap-
oration pipe and hold the clip.
L
= 27.5f2.5
mm (1.083-_+0.098 in)
k--J
B2M1195A
(1) Hose
(2) Clip
(3) Pipe
FU(S0HC)-56