Subaru IMPREZA 2002 Service Manual page 290

ACCELERATOR PEDAL
SPEED CONTROL SYSTEMS
9) Remove the accelerator pedal connecting bolt
14) Separate the accelerator cable and bracket.
from accelerator pedal bracket.
10) Disconnect the grommet from toe board.
NOTE:
From inside the compartment, push grommet into
hole.
11) Pull out the cable from the toe board hole.
12) Disconnect the accelerator cable bushing from
accelerator pedal lever.
I
13) Disconnect the accelerator cable stopper from
bracket.
B: INSTALLATION
Install in the reverse order of removal.
CAUTION:
If cable clamp is damaged, replace it with a
new one.
Never fail to cover the outer cable end with
boot.
Be careful not to kink the accelerator cable.
Always use new clevis pins.
s
P-4