Controlling Relays (Not For Hipath 500/Hipath 2000); Radio Paging (Not For U.s., Not For Hipath 500); Simple Paging Equipment - Siemens HiPath 500 Operating Instructions Manual

Using Other Functions
Step by Step
40
Controlling Relays
(Not for HiPath 500/HiPath 2000)
If this feature is configured (contact the service person-
nel), you can turn up to four relays on and off to control
different facilities (such as a door opener).
Depending on how they are programmed, you can
switch the relays on and off or switch them on and have
them switched off automatically after a timeout.
n
Lift the handset.
or Enter the code for "on" or "off".
w
... Enter the relay.
Radio Paging (Not for U.S., Not for
HiPath 500)
If paging equipment is connected to your system (con-
tact the service personnel), you can contact people via
their pocket receivers.
The pocket receiver indicates to the person you are
looking for that someone is trying to get in touch. The
person you page can then go to the nearest telephone
and call you.
The operating procedures differ according to the type of
radio paging equipment connected (simple or enhanced
paging equipment).

Simple Paging Equipment

Paging:
To be paged, you must have activated a call ringing
group
redirection (contact the service personnel) to the inter-
nal station number of your paging equipment.
A call request is then signaled automatically.
Special features must be taken into consider-
ation if your telephone operates with
HiPath 5000 (system networking via PC net-
work) Page 51!
Page 45, call forwarding Page 29, or call