Controlling Relays (Not For Hipath 500); Sensors (Hipath 3300/3350/3500/3550 Only); Radio Paging (Not For U.s., Not For Hipath 500) - Siemens HiPath 500 Operating Instructions Manual

Using Other Functions
Step by Step
*90=Control Relay On?
#90=Control Relay Off?
qmd
or
90

Controlling Relays (Not for HiPath 500)

If this function has been configured (contact your ser-
vice personnel), you can turn up to four relays on and off
to control different facilities (such as a door opener).
Depending on how they are programmed, you can
switch the relays on and off or switch them on and have
them switched off automatically after a timeout.
Select and confirm.
or
or
rmd
Enter the code for "on" or "off".
e h
... Enter the relay.
Sensors (HiPath 3300/3350/3500/3550
Only)
If this function has been configured (contact your ser-
vice personnel), sensors detect signals, causing your
phone to ring and a message to appear on your screen.
Radio Paging (Not for U.S., Not for
HiPath 500)
If paging equipment is connected to your system (con-
tact your service personnel), you can contact people via
their pocket receivers.
The pocket receiver indicates to the person you are
looking for that someone is trying to get in touch. The
person you page can then go to the nearest telephone
and call you.
The operating procedures differ according to the type of
radio paging equipment connected (simple or enhanced
paging equipment).
Special features must be taken into consider-
ation if your telephone operates with
HiPath 5000 (system networking via PC net-
work) Page 110!