B Status Response; Serial And Ethernet Interface - InfoPrint 6700 Series Programmer's Reference Manual

B

Serial And Ethernet Interface

1. Auto Status Response
The Auto Status Response feature is enabled or disabled by the status
response parameter in the XS command.
Once an XS command enables the Auto Status Response feature, it will stay
enabled until another XS command disables it. The status response menu
defines whether the Auto Status Response after power up must be enabled or
disabled. If set to 'On Request+Auto', Auto Status Response is enabled until
disabled by an XS command.
If the Auto Status Response is enabled, a response will be sent to the host
•
after processing the Issue (XS) command when
•
•
•
at the end of the Feed (T) command.
•
if one of the errors listed in the table below occurs.
2. On Status Request command ( WS-command )
The Status Request command is enabled by selecting either the On Request
Only or the On Request + Auto option in the TGL SETUP > Status Response
menu. The printer sends its current status to the host, regardless of the option
"status response" in the label issue command (XS). The remaining count
indicates the remaining number of labels in the current batch.
Status Response
the Issue Mode parameter is set to Batch Mode, after printing the
designated number of labels.
the Issue Mode parameter is set to Strip Mode, after printing one
label.
29