Xs Sensor Param; Xs Media 'C' Act; Xs Media 'D' Act; Ar Pre-Feed Cmd - InfoPrint 6700 Series Programmer's Reference Manual

TGL SETUP Submenus

XS Sensor Param

This option allows you to choose whether the sensor type parameter in the XS
command will be processed or ignored. When you select "Ignore" TGL will
use the sensor type as configured through "Gap/Mark Sensor" under the
"CALIBRATE CTRL" menu.
The factory default is Process.

XS Media 'C' Act

This option defines which media mode TGL will operate on receipt of a 'C'
(strip mode) for the issue mode parameter in the XS command. Any of the
supported media modes can be selected. When you select "Ignore," TGL will
use the issue mode as configured through "Media Handling" under the
"MEDIA CONTROL" menu.
The factory default is Continuous.

XS Media 'D' Act

This option defines which media mode TGL will operate on receipt of a 'D'
(strip mode) for the issue mode parameter in the XS command. Any of the
supported media modes can be selected. When you select "Ignore," TGL will
use the issue mode as configured through "Media Handling" under the
"MEDIA CONTROL" menu.
Tear-Off is the default for 6700 printers. Tear-Off Strip is the default for
6700-M40 printers.

AR Pre-Feed CMD

This option allows you to choose whether the engine command for a paper
pre-feed (AR) should be processed or ignored. When you select "Ignore," the
paper will not pre-feed.
The factory default is Process.

AX Fine Adj. CMD

This option allows you to choose whether the engine command for a position
fine adjust (AX) should be processed or ignored. When you select "Ignore,"
the paper will not fine-adjust.
The factory default is Process.
11