The Sleep Timer is used to set the period during which the system enters and exits low-power modes
PM1 and PM2. The Sleep Timer is also used to maintain timing in Timer 2 when entering power mode
PM1 or PM2.
The main features of the Sleep Timer are the following:
•
24-bit timer up-counter operating at 32-kHz clock rate
•
24-bit compare with interrupt and DMA trigger
•
24-bit capture
...........................................................................................................................
Topic
11.1
General
11.2
Timer Compare
11.3
Timer Capture
11.4
Sleep Timer Registers
128
Sleep Timer
...........................................................................................................
.................................................................................................
..................................................................................................
.......................................................................................
Copyright © 2009–2014, Texas Instruments Incorporated
Chapter 11
SWRU191F – April 2009 – Revised April 2014
Sleep Timer
SWRU191F – April 2009 – Revised April 2014
Submit Documentation Feedback
Page
129
129
129
130