Configuring Stack; Overview - HP 1910 User Manual

Configuring stack

Overview

The stack management feature enables you to configure and monitor a group of connected switches by
logging in to one switch in the stack, as shown in
Figure 26 Network diagram
To set up a stack for a group of connected switches, you must log in to one switch to create the stack. This
switch is the master switch for the stack, and you configure and monitor all other member switches on the
master switch. The ports that connect the stack member switches are called stack ports.
Configuration task list
Task
Configuring the master device of a stack:
Configuring global stack parameters
Configuring stack ports
Configuring stack member devices:
Configuring stack ports
Figure 26.
Remarks
Required.
Configure a private IP address pool and set up the stack.
By default, no IP address pool is configured for a stack and no
stack is set up.
Required.
Configure the ports connected to member devices as stack
ports.
By default, no ports are configured as stack ports.
Required.
Configure ports connected to the master device or other stack
member devices as stack ports.
By default, no ports are configured as stack ports.
39