HP 1910 User Manual page 260

Field
Power priority
PD requested power value
PSE allocated power value
Link aggregation supported
Link aggregation enabled
Aggregation port ID
Maximum frame Size
Device class
Media policy type
Unknown Policy
VLAN tagged
Media policy VlanID
Media policy L2 priority
Media policy Dscp
HardwareRev
FirmwareRev
SoftwareRev
Description
Power supply priority on a PD:
•
Unknown—Unknown priority.
•
Critical—Priority 1.
•
High—Priority 2.
•
Low—Priority 3.
Power (in watts) required by the PD that connects to the port.
Power (in watts) supplied by the PSE to the connecting port.
The support of the neighbor for link aggregation
The enable status of link aggregation on the neighbor
Link aggregation group ID. It is 0 if the neighbor port is not assigned to any
link aggregation group.
The maximum frame size supported on the neighbor port.
MED device type:
•
Connectivity device—An intermediate device that provide network
connectivity.
•
Class I—a generic endpoint device. All endpoints that require the
discovery service of LLDP belong to this category.
•
Class II—A media endpoint device. The class II endpoint devices support
the media stream capabilities in addition to the capabilities of generic
endpoint devices.
•
Class III—A communication endpoint device. The class III endpoint
devices directly support end users of the IP communication system.
Providing all capabilities of generic and media endpoint devices, Class III
endpoint devices are used directly by end users.
Media policy type:
•
Unknown
•
Voice
•
Voice signaling
•
Guest voice
•
Guest voice signaling
•
Soft phone voice
•
Videoconferencing
•
Streaming video
•
Video signaling
Indicates whether the media policy type is unknown.
Indicates whether packets of the media VLAN are tagged.
ID of the media VLAN.
Layer 2 priority.
DSCP precedence.
Hardware version of the neighbor.
Firmware version of the neighbor.
Software version of the neighbor.
199