Setting The Super Password - HP 1910 User Manual

Table 16 Configuration items
Item
Username
Access Level
Password
Confirm Password
Service Type

Setting the super password

A management level user can set the password for non-management level users to switch to the
management level. If no such password is configured, no switchover can occur.
To set the super password:
Select Device > Users from the navigation tree.
1.
Click the Super Password tab.
2.
Figure 74 Super password
Configure a super password as described in
3.
Click Apply.
4.
Description
Set a username for the user.
Select an access level for the user.
Users of different levels can perform different operations. User levels, in order from low
to high, are as follows:
•
Visitor—Users of this level can only perform ping and traceroute operations. They can
neither access the data on the device nor configure the device.
•
Monitor—Users of this level can perform ping and traceroute operations and access
the data on the device but cannot configure the device.
•
Configure—Users of this level can perform ping and traceroute operations, access
data on the device, and configure the device, but they cannot upgrade the host
software, add/delete/modify users, or back up/restore the configuration file.
•
Management—Users of this level can perform any operations on the device.
Set the password for the user.
Enter the same password again. Otherwise, the system will prompt that the two
passwords are not consistent when you apply the configuration.
Select the service types for the user to use, including FTP and Telnet. The terminal service
allows users to log in from the console port. You must select at least one service type.
Table 17.
43