Configuring The Snmp Trap Function - HP 1910 User Manual

Item
Confirm Authentication Password
Privacy Mode
Privacy Password
Confirm Privacy Password
ACL

Configuring the SNMP trap function

Select Device > SNMP from the navigation tree.
1.
Click the Trap tab.
2.
The Trap tab appears.
Figure 116 Trap tab
Select Enable SNMP Trap.
3.
Click Apply to enable the SNMP trap function.
4.
Click Add.
5.
The page for adding a target host of SNMP traps appears.
Description
Auth/Priv.
Confirm authentication password must be the same with the
authentication password.
Select a privacy mode (including DES56, AES128, and 3DES) when the
security level is Auth/Priv.
Set the privacy password when the security level is Auth/Priv.
Confirm privacy password must be the same with the privacy password.
Associate a basic ACL with the user to restrict the source IP address of
SNMP packets, that is, you can configure to allow or prohibit SNMP
packets with a specific source IP address, so as to allow or prohibit the
specified NMS to access the agent by using this user name.
83