LLDP configuration examples
LLDP basic settings configuration example
Network requirements
As shown in
station (NMS) can determine the status of the link between Switch A and MED and the link between
Switch A and Switch B.
Figure 212 Network diagram
NMS
Configuring Switch A
Enable LLDP on GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2. (Optional. By default, LLDP is
1.
enabled on Ethernet ports.)
Set the LLDP operating mode to Rx on GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2:
2.
Select Network > LLDP from the navigation tree.
a.
By default, the Port Setup tab is displayed.
Select port GigabitEthernet1/0/1 and GigabitEthernet1/0/2.
b.
Click Modify Selected.
c.
The page shown in
Figure
212, configure LLDP on Switch A and Switch B so that the network management
GE1/0/1
GE1/0/2
Switch A
Figure 214
MED
GE1/0/1
Switch B
appears.
204