Finishing Configuration Wizard - HP 1910 User Manual

Item
Configure IPv4
address
Configure IPv6
link-local address

Finishing configuration wizard

After finishing the management IP address configuration, click Next.
The page displays your configurations. Review the configurations and if you want to modify the settings
click Back to go back to the page. Click Finish to confirm your settings and the system performs the
configurations.
Description
DHCP Configure how the VLAN interface obtains an IPv4 address.
•
DHCP—Specifies the VLAN interface to obtain an IPv4 address by
BOOTP
DHCP.
•
BOOTP—Specifies the VLAN interface to obtain an IPv4 address
through BOOTP.
Manual
•
Manual—Allows you to specify an IPv4 address and a mask length.
IPv4 Specify an IPv4 address and the mask length for the VLAN interface.
address Dotted decimal notation is also allowed for the mask length field.
These two fields are configurable if Manual is selected.
MaskLen
Specify the gateway IP address.
By default, the gateway IP address is not specified. Specify the gateway IP
Gateway
address if the device needs to connect to the Internet.
Auto Configure how the VLAN interface obtains an IPv6 link-local address.
•
Auto—Specifies the device to automatically generate an link-local
address based on the link-local address prefix (FE80::/64) and the link
Manual
layer address of the interface.
•
Manual—Allows you to specify an IPv6 address.
Specify an IPv6 link-local address for the VLAN interface.
IPv6
This field is configurable if Manual is selected. The address prefix must be
address
FE80::/64.
37