Protocols And Standards; Recommended Radius Configuration Procedure; Configuring Radius Servers - HP 1910 User Manual

Figure 400 Format of attribute 26

Protocols and standards

RFC 2865, Remote Authentication Dial In User Service (RADIUS)
•
RFC 2866, RADIUS Accounting
•
RFC 2867, RADIUS Accounting Modifications for Tunnel Protocol Support
•
RFC 2868, RADIUS Attributes for Tunnel Protocol Support
•
RFC 2869, RADIUS Extensions
•

Recommended RADIUS configuration procedure

The RADIUS scheme configured through the web interface is named system.
If the switch does not contain a RADIUS scheme named system, it automatically creates the scheme when
you select Authentication > RADIUS to enter the RADIUS module.
Step
1. Configuring RADIUS authentication
servers
2. Configuring RADIUS accounting
servers
3. Configuring RADIUS
communication parameters

Configuring RADIUS servers

Select Authentication > RADIUS from the navigation tree.
1.
The RADIUS server configuration page appears.
Remarks
(Required.)
Configure the primary and secondary RADIUS authentication
servers.
By default, no RADIUS authentication server is configured.
For more information about the configuration procedure, see
"Configuring RADIUS servers."
(Optional.)
Configure the primary and secondary RADIUS accounting servers.
By default, no RADIUS accounting server is configured.
For more information about the configuration procedure, see
"Configuring RADIUS servers."
(Required.)
Configure the parameters used for information exchange between
the switch and RADIUS servers.
379