Displaying Snmp Packet Statistics - HP 1910 User Manual

Figure 117 Adding a target host of SNMP traps
Configure the settings for the target host as described in
6.
Click Apply.
7.
Table 38 Configuration items
Item
Destination IP Address
Security Name
UDP Port
Security Model
Security Level

Displaying SNMP packet statistics

Select Device > SNMP from the navigation tree.
The page for displaying SNMP packet statistics appears.
Description
Select the IPv4 or IPv6 option, and enter the specific type of destination IP address.
Set the security name, which can be an SNMPv1 community name, an SNMPv2c
community name, or an SNMPv3 user name.
Set UDP port number.
IMPORTANT:
Default port number is 162, which is the SNMP-specified port used for receiving traps
on the NMS. Generally (such as using iMC or MIB Browser as the NMS), you can use
the default port number. To change this parameter to another value, you need to make
sure that the configuration is the same with that on the NMS.
Select the security model, that is, the SNMP version. Make sure that the SNMP
version is the same with that on the NMS; otherwise, the NMS cannot receive any
trap.
Set the authentication and privacy mode for SNMP traps when the security model is
selected as v3. The available security levels are: no authentication no privacy,
authentication but no privacy, and authentication and privacy.
When the security model is selected as v1 or v2c, the security level is no
authentication no privacy, and cannot be modified.
84
Table 38.