Enabling The Dhcp Relay Agent On An Interface - HP 1910 User Manual

Click Apply.
4.
Table 96 Configuration items
Item
Server Group ID
IP Address

Enabling the DHCP relay agent on an interface

Select Network > DHCP from the navigation tree to enter the DHCP Relay page shown in
1.
286.
In the Interface Config area, click the
2.
Figure 288 Configuring a DHCP relay agent interface
Configure the DHCP relay agent on the interface as shown in
3.
Click Apply.
4.
Table 97 Configuration items
Item
Interface Name
DHCP Relay
Address Match Check
Server Group ID
Description
Enter the ID of a DHCP server group.
You can create up to 20 DHCP server groups.
Enter the IP address of a server in the DHCP server group.
The server IP address cannot be on the same subnet as the IP address of the DHCP
relay agent; otherwise, the client cannot obtain an IP address.
Description
Displays the name of a specific interface.
Enable or disable the DHCP relay agent on the interface.
If the DHCP relay agent is disabled, the DHCP server is enabled on the interface.
Enable or disable IP address check.
With this function enabled, the DHCP relay agent checks whether a requesting
client's IP and MAC addresses match a binding (dynamic or static) on the DHCP
relay agent. If not, the client cannot access outside networks via the DHCP relay
agent. This prevents invalid IP address configuration.
Correlate the interface with a DHCP server group.
A DHCP server group can be correlated with multiple interfaces.
280
icon for a specific interface.
Table 97.
Figure