HP 1910 User Manual page 445

Figure 403 Network diagram
Configuration procedure
Enable the Telnet server function, and configure the switch to use AAA for Telnet users. (Details not
1.
shown.)
Configure IP addresses for the interfaces. (Details not shown.)
2.
Configure RADIUS scheme system:
3.
# Configure the RADIUS authentication server.
Select Authentication > RADIUS from the navigation tree.
a.
The RADIUS server configuration page appears.
Configure the following parameters, as shown in
b.
Select Authentication Server as the server type.
Enter 10.110.91.146 as the IP address of the primary authentication server
Enter 1812 as the UDP port of the primary authentication server.
Select active as the primary server status.
Click Apply.
c.
Figure 404 Configuring the RADIUS authentication server
# Configure the RADIUS accounting server.
Select Authentication > RADIUS from the navigation tree.
a.
The RADIUS server configuration page appears.
Configure the following parameters, as shown in
b.
Select Accounting Server as the server type.
Enter 10.110.91.146 as the IP address of the primary accounting server.
Enter 1813 as the UDP port of the primary accounting server.
Figure 404.
Figure 405.
384