Configuring A Rule For An Advanced Ipv4 Acl - HP 1910 User Manual

Item
Rule ID
Action
Check Fragment
Check Logging
Source IP Address
Source Wildcard
Time Range

Configuring a rule for an advanced IPv4 ACL

Select QoS > ACL IPv4 from the navigation tree.
1.
Click the Advance Setup tab to enter the rule configuration page for an advanced IPv4 ACL.
2.
Description
Select the Rule ID box and enter a number for the rule.
If you do not specify the rule number, the system will assign one automatically.
NOTE:
If the rule number you specify already exists, the following operations modify the
configuration of the rule.
Select the action to be performed for IPv4 packets matching the rule.
•
Permit—Allows matched packets to pass.
•
Deny—Drops matched packets.
Select this box to apply the rule to only non-first fragments.
If you do no select this box, the rule applies to all fragments and
non-fragments.
Select this box to keep a log of matched IPv4 packets.
A log entry contains the ACL rule number, operation for the matched packets,
protocol that IP carries, source/destination address, source/destination port
number, and number of matched packets.
Select the Source IP Address box and enter a source IPv4 address and a
wildcard mask, in dotted decimal notation.
Select the time range during which the rule takes effect.
428