HP 1910 User Manual page 86

Item Description
Set the transmission rate of the port.
Available options include:
•
•
•
•
•
Speed
•
•
•
•
•
•
Set the duplex mode of the port.
•
Duplex
•
•
Set the link type of the current port, which can be access, hybrid, or trunk. For more
information, see
Link Type
To change the link type of a port from trunk to hybrid or vice versa, you must first set its link
type to access.
Set the default VLAN ID of the interface. For more information about setting the PVID, see
"Configuring
PVID
To make sure a link properly transmits packets, the trunk or hybrid ports at the two ends of
the link must have the same PVID.
10—10 Mbps.
100—100 Mbps.
1000—1000 Mbps.
Auto—Auto-negotiation.
Auto 10—Auto-negotiated to 10 Mbps.
Auto 100—Auto-negotiated to 100 Mbps.
Auto 1000—Auto-negotiated to 1000 Mbps.
Auto 10 100—Auto-negotiated to 10 or 100 Mbps.
Auto 10 1000—Auto-negotiated to 10 or 1000 Mbps.
Auto 100 1000—Auto-negotiated to 100 or 1000 Mbps.
Auto 10 100 1000—Auto-negotiated to 10, 100, or 1000 Mbps.
Auto—Auto-negotiation.
Full—Full duplex.
Half—Half duplex.
"Configuring
IMPORTANT:
VLANs."
IMPORTANT:
25
VLANs."