Configuring Snmp Trap Function - HP FlexNetwork NJ5000 User Manual

Item
Group Name
Authentication Mode
Authentication Password
Confirm Authentication
Password
Privacy Mode
Privacy Password
Confirm Privacy Password
ACL

Configuring SNMP trap function

Select Device > SNMP from the navigation tree.
1.
Click the Trap tab.
2.
The Trap tab appears.
Figure 95 Traps configuration
Select Enable SNMP Trap.
3.
Click Apply to enable the SNMP trap function.
4.
Description
Select an SNMP group to which the user belongs:
•
When the security level is NoAuth/NoPriv, you can select an
SNMP group with no authentication no privacy.
•
When the security level is Auth/NoPriv, you can select an
SNMP group with no authentication no privacy or
authentication without privacy.
•
When the security level is Auth/Priv, you can select an SNMP
group of any security level.
Select an authentication mode (including MD5 and SHA) when the
security level is Auth/NoPriv or Auth/Priv.
Set the authentication password when the security level is
Auth/NoPriv or Auth/Priv.
The confirm authentication password must be the same with the
authentication password.
Select a privacy mode (including DES56, AES128, and 3DES)
when the security level is Auth/Priv.
Set the privacy password when the security level is Auth/Priv.
The confirm privacy password must be the same with the privacy
password.
Associate a basic ACL with the user to restrict the source IP
address of SNMP packets. To allow or prohibit the specified NMS to
access the agent by using this user name, you can allow or prohibit
SNMP packets with a specific source IP address.
95