Configuring Snmp Trap Function - HP 1920 Gigabit Ethernet Switch Series User Manual

Table 37 Configuration items
Item
User Name
Security Level
Group Name
Authentication Mode
Authentication Password
Confirm Authentication
Password
Privacy Mode
Privacy Password
Confirm Privacy Password
ACL

Configuring SNMP trap function

1. Select Device > SNMP from the navigation tree.
2. Click the Trap tab.
The Trap tab appears.
Description
Set the SNMP user name.
Select the security level for the SNMP group. The available security
levels are:
•
NoAuth/NoPriv—No authentication no privacy.
•
Auth/NoPriv—Authentication without privacy.
•
Auth/Priv—Authentication and privacy.
Select an SNMP group to which the user belongs:
•
When the security level is NoAuth/NoPriv, you can select an
SNMP group with no authentication no privacy.
•
When the security level is Auth/NoPriv, you can select an SNMP
group with no authentication no privacy or authentication without
privacy.
•
When the security level is Auth/Priv, you can select an SNMP
group of any security level.
Select an authentication mode (including MD5 and SHA) when the
security level is Auth/NoPriv or Auth/Priv.
Set the authentication password when the security level is
Auth/NoPriv or Auth/Priv.
The confirm authentication password must be the same with the
authentication password.
Select a privacy mode (including DES56, AES128, and 3DES) when
the security level is Auth/Priv.
Set the privacy password when the security level is Auth/Priv.
The confirm privacy password must be the same with the privacy
password.
Associate a basic ACL with the user to restrict the source IP address of
SNMP packets. To allow or prohibit the specified NMS to access the
agent by using this user name, you can allow or prohibit SNMP
packets with a specific source IP address.
121