Insert Tray 2 (Tray Missing) - Xerox Phaser 6180 Service Manual

Insert Tray 2 (Tray Missing)

Phaser 6180 Color Laser Printer Service Manual
The Tray 2 Size Switch indicates that Tray 2 is not installed.
Applicable Chain Link
■ Chain Link
■
Chain Link
Initial Actions
■ Remove the tray and inspect the tray cavity to ensure that it is free of
obstructions or debris.
■ Reinstall the tray and cycle printer power.
■ If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Tray 2 Size Switch, PL7.1.18
■
MCU Board, PL9.1.20
■
Right Side Harness, PL10.1.15
■
Troubleshooting Procedure Table
Step Actions and Questions
1 Check the tray for correct installation.
Is Tray 2 correctly installed?
Does the error still occur?
2
3 Perform the Tray 2 Paper Size test
(page 4-38):
Test
Does the switch operate properly?
4 Check the Right Side Harness for
continuity.
1. Disconnect P/J23 from the MCU
Board.
2. Check continuity between P/J23 <=>
P/J231.
Replace the Tray 2 Size Switch
5
(page 8-72). Does the error still
occur?
024-946: Insert Tray 2 (Tray Missing)
077-912: Insert Tray 2
Service Mode > Sensor
> Tray2 Paper Size.
Error Messages and Codes
Wiring and Plug/Jack Map References
"Map 2 - Laser Unit" on page 10-11
■
"Map 4 - LVPS and MCU Board" on
■
page 10-13
"Feeder" on page 10-36
■
Yes
Go to step 3.
Go to step 3.
Complete.
Go to step 5.
Replace the
MCU Board
(page 8-87).
No
Reseat Tray 2.
Complete.
Go to step 4.
Replace the
Right Side
Harness.
Complete.
3-59