Rear Brake Caliper Assembly - Honda VTR1000F Service Manual

ASSEMBLY
I
CALIPER PISTON
DUST SEAL
PISTON SEAL
PAD SPRING
Coat new piston and dust seals with clean brake
fluid and install them in the seal grooves in the
caliper.
Coat the caliper piston with clean brake fluid and
install it into the caliper cylinder with the opening
toward the pads.
Install the pad spring onto the caliper body as
shown.
Check the caliper boot and replace it if it is hard,
deteriorated or damaged.
Apply silicone grease to the inside of the boot.
Install the boot and collar into the caliper.
HYDRAULIC BRAKE
BLEED VALVE
6 N·m (0.6 kgf·m , 4.3 Ibf·ft)
cw
CALIPER PIN BOLT
COLLAR
PISTON SEAt------!L..If"
:!P
OUST SEAL
CAUPSR PlsrD;N
15-21