Honda VTR1000F Service Manual page 399

VTR1000F (1) ADDENDUM
24-40
IMMOBILIZER INDICATOR
Remove the combination meter from the stay (page
24-26).
Perform the following inspections with the combi-
nation meter connector connected.
POWER INPUT LINE INSPECTION
Measure the voltage between the black/brown (+)
and green (-) wire terminals.
Turn the ignition switch ON.
There should be battery voltage.
IMMOBILIZER INDICATOR LINE INSPECTION
Measure the voltage between the white/red (+)
and green (-) wire terminals.
Turn the ignition switch ON.
There should be battery voltage.
NOTE:
There should be no voltage for approx. two
seconds after the ignition switch is turned ON, then
the battery voltage should appear, if the system is
normal.
IGNITION CONTROL MODULE (lCM)
Remove the seat cowl (page 2-2).
Disconnect the ICM connector.
Perform the following inspections at the wire
harness side connector of the ICM.
IMMOBILIZER INDICATOR LINE INSPECTION
Measure the voltage between the white/red wire
terminal (+) and ground (-).
Turn the ignition switch ON.
There should be battery voltage.
POWER INPUT LINE INSPECTION
Measure the voltage between the black/white wire
terminal (+) and ground (-).
Turn the ignition switch ON.
There should be battery voltage.
Green (-)
Green (-)
ICM CONNECTOR White/Red (+)