Honda VTR1000F Service Manual page 167

Press in the
Press the needle bearing in the clutch outer until it
bearing with the
is flush with the inner edge of the clutch outer,
marking side
using the special tools.
facing up.
TOOLS:
Driver 077 49-0010000
Attachment, 42
x
47 mm 07746-0010300
Pilot, 35 mm 077 46-0040800
ASSEMBLY
Coat the clutch outer guide with molybdenum oil
solution and install it onto the mainshaft with the
flange side facing the crankcase.
Install the oil pump drive sprocket, drive chain and
driven sprocket as a set with the index lines on the
driven sprocket facing in.
Apply locking agent to the oil pump driven sprocket
bolt threads and install the washer and bolt.
NOTE:
Tighten the driven sprocket bolt to the specified
torque after installing the clutch outer.
Apply molybdenum oil solution to the clutch outer
needle bearing.
Align the gear teeth of the scissors gears (primary
drive gear and sub-gear) by inserting a screwdriver
into the gear holes, and install the clutch outer.
CLUTCH/GEARSHIFT LINKAGE
ATTACHMENT
PILOT
9-17