Starter Reduction Gear - Honda VTR1000F Service Manual

AL TERNATORISTARTER CLUTCH
10-6
Install the sprag clutch into the starter clutch outer
as shown.
Apply locking agent to the starter clutch bolt
threads.
Install the starter clutch assembly onto the flywheel
and install the bolts.
Hold the flywheel with the special tool and tighten
the bolts.
TOOL:
Flywheel holder
07725-0040000
TORQUE: 23 N·m (2.3 kgf·m. 17Ibf·ft)
Install the starter driven gear while turning it coun-
terclockwise.
Make sure that the starter driven gear turns counter-
clockwise smoothly and does not turn clockwise.
Install the flywheel (page 10-7).
STARTER REDUCTION GEAR
Remove the front cylinder cam sprockets (page 8-4).
Remove the flywheel (page 10-4).
Remove the bolt and cam chain guide.
Pull the starter reduction gear shaft and remove the
reduction gear.
c·