Honda VTR1000F Service Manual page 88

FUELSVSTEM
5-14
Install the left set plate onto the front carburetor as
shown.
Install the right set plate onto the rear carburetor so
that the pin of the throttle sensor is positioned
between the tabs of the throttle shaft.
CAUTION :
Do not remove the throttle sensor from the set
plate unless it requires replacement.
It can cause the throttle sensor getting out of
position resulting in improper ignition timing.
Install the fuel tubes and dowel pins, and assemble
the front and rear carburetors.
OQWEI. PINS - --